5052 aluminum plate ,5052 alu plate ,aluminum plate 5052-全讯新

2017-05-29 12:13:52

5052 aluminum plate for al - mg alloy aluminum, magnesium is the main alloy elements in 5052 aluminum alloy, is one of the most widely used antirust aluminium, the alloy of high strength, especially first has anti-fatigue strength: plastic with high corrosion resistance, can not heat treatment to strengthen, in a cold work hardening plasticity is good, when the cold work hardening plasticity is low, good corrosion resistance, good weldability, cutting performance is bad, can be polished.

aluminum, magnesium alloy contains a small amount of manganese, chromium, beryllium, titanium, etc. alloy of manganese in addition to the small amount of solid solution, most form mnal6. the effect of chromium in 5052 aluminum and manganese are similar, improve the ability of resistance to stress corrosion cracking, increased the strength of base metal and weld, reduce the tendency to welding crack, but the content is generally not more than 0.35%.

5052 aluminum plate use is mainly used in the request high plasticity and good weldability, are commonly used to transport vehicles, ships of sheet metal parts, instrument, lamps stent and rivet, metal products, electrical enclosure, etc. can also be used in the manufacture of aircraft fuel tank, oil pipe, aerospace aluminum alloy material, is a typical antirust alloy material.

5052 aluminum plate specification

aluminum plate thickness: 0.15 mm to 50 mm, width: 100 mm - 2000 mm, length: 1000 mm - 9000 mm,

aluminum coil thickness: 0.05 mm to 15 mm, width is: 15 mm - 2000 mm

insulation aluminum plate thickness: 0.3 mm to 0.9 mm width: 500 mm - 1000 mm length: no

non-slip aluminum plate thickness: 1 mm - 10 mm width: 1000 mm - 1500 mm length: 2000-3000 - mm

embossed aluminum sheet thickness: 0.1 mm to 0.1 mm width: 500 mm - 1200 mm length: no

the surface quality

1, the surface are not allowed to have a crack, corrosion spots and nitrate.

2, is allowed on the surface depth is less than 8% of the nominal size peeling defect part wall thickness, air bubbles, surface coarse and local mechanical damage, but the defect depth is not more than 0.5 mm, defect sheet with a total area of no more than 5% of the total area.

3, allow the supplier along the longitudinal profiles polishing to the surface is smooth.

4, other requirements: you have the demand side and the supplier.